KDL-40BX450/40BX451/46BX450/46BX451
15
Components not identified by a part number or
description are not stocked because they are seldom
required for routine service.
The component parts of an assembly are indicated by the
reference numbers in the far right column of the parts list
and within the dotted lines of the diagram.
*
Items marked with an asterisk are not stocked since
they are seldom required for routine service. Expect
some delay when ordering these components.
NOTE: The components identified by shading
and
!
mark are critical for safety. Replace only
with part number specified.
NOTE: The components identified by a red outline and a
mark contain
confidential information. Specific instructions must be adhered to whenever
these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
NOTE: Les composants identifies per un trame et
une marque
!
sont critiques pour la securite.
Ne les remplacer que par une piece portant le
numero specifie.
(Check the Sony Authorized Servicer Portal at
website for any additional service related issues.)
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
TABLE-TOP STAND AND REAR COVER REMOVAL
A Gently place LCD TV face down onto a soft cloth and remove 3 screws from Table-Top Stand.
B Remove screws from Rear Cover.
17 from KDL-40BX450/40BX451 Only
19 from KDL-46BX450/46BX451 Only
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
REF. NO.
PART NO.
DESCRIPTION
[ASSEMBLY INCLUDES]
1
4-409-856-11
REAR COVER (40APOF)
[2]
(KDL-40BX450/40BX451 ONLY)
1
4-409-857-11
REAR COVER (46APOF)
[2]
(KDL-46BX450/46BX451 ONLY)
2
N/A
BRACKET, VESA (40APOF)
3
X-2583-463-1
STAND ASSEMBLY (40APOF)
(KDL-40BX450/40BX451 ONLY)
3
X-2583-464-1
STAND ASSEMBLY (46APOF)
(KDL-46BX450/46BX451 ONLY)
4
2-580-608-11
SCREW, +PSW M5X16
(SCREWS TO ATTACH TABLE-TOP STAND TO LCD TV)
For product protection and safety reasons, Sony strongly recommends that
you use the screws provided with the TV.
CAUTION: These screws cannot be used to secure the TV to the Wall
Mount Brackets
3
4
2
1
CAUTION: Do not damage the Power Board Connector and AC Power Cord when removing the Rear Cover.
C Carefully lift Rear Cover from the bottom and push
forward to release top hooks.
D Hold Power Supply Cord while lifting up Rear Cover,
then pass Power Supply Cord through Rear Cover
opening.
Do not pull the AC Power Cord or damage
the connector on the Power Board.