38
GB
Auto Start-up
You can run the initial set-up that appeared when you first connected the TV, and
select the language and country/area, the region (Australian model only), or tune in
all available channels again.
Even if you have made the settings when you first connected the TV, you may need
to change the settings after moving house, or to search for newly launched
channels.
Language
Sets the language displayed on the menu screens.
Product Information
Displays product information of the TV.
Factory Settings
Resets all settings to factory settings except for the “Programme Block” setting,
“Favourite” setting, and programme preset data. After completing this process, the
initial set-up screen is displayed. Completing auto tuning in initial set-up will reset
the settings that are not reset by “Factory Settings.” To retain the settings, skip the
“Auto Tuning.”
Analogue Set-up
Programme List
Display
Select “Off” to hide the list of analogue channels from the XMB™
(XrossMediaBar).
1 Digit Direct
When “1 Digit Direct” is set to “On,” you can select an analogue channel using one
preset number button (0 – 9) on the remote.
~
• When “1 Digit Direct” is set to “On,” you cannot select channel numbers 10 and
above by entering two digits on the remote.
Favourite Set-up
Allows you to set your favourite channels by assigning the desired channel
numbers.
To reset the favourite channels, select “– – –.”
Auto Tuning
Tunes in all the available analogue channels.
You can retune the TV after moving house, or to search for newly launched
channels.
Programme Sorting
Changes the order of analogue channels stored in the TV.
1
Press
F
/
f
to select the channel you want to move to a new position, then press
.
2
Press
F
/
f
to select the new position for the channel, then press
.
Programme Labels
Assigns a channel name of your choice, up to five letters or numbers. The name
appears briefly on the screen when you select the channel.
1
Press
F
/
f
to select the channel you want to name, then press
.
2
Press
F
/
f
to select the desired letter or number (“_” for a blank space), then
press
g
.
If you enter a wrong character
Press
G
/
g
to select the wrong character. Then, press
F
/
f
to select the correct
character.
3
Repeat step 2 until you finish entering the name.
4
Press
to exit the labeling procedure.
Programme Block
Blocks an individual channel from being watched.
1
Press
F
/
f
to select the channel you want to block, then press
.
2
Press
F
/
f
to select “Block,” then press
.
To watch the channel, select “Allow.”
Intelligent Picture
On with Indicator
Automatically reduces the picture noise. The signal level bar
is displayed when the channel is changed or the display is
changed from an input screen to a TV programme.
On
Automatically reduces the picture noise.
