Sony BluetoothH MEX-BT5100, Руководство по обслуживанию

Страница: 5 / 80

MEX-BT5100
5
FACTORY SHIPMENT MODE
Even if the set is reset, bluetooth system menu setting, connected
registration equipment, and telephone book function, etc. recorded
in the
fl
ash memory are not initialized. It is necessary to execute
factory shipment mode to initialize them.
Procedure:
1. Turn off the setting of the bluetooth signal, and power supply
is turned off.
2. Press the [4]
t
[5]
t
[1] ([1] is pressed for two seconds)
button of the set sequentially, and enter the test mode.
3. Press the [1] button for two seconds of the set, and the DIAG
information is initialized.
4. Press the [6] button for two seconds of the set, and the blue-
tooth setting item preserved in NOR FLASH is initialized.
5. Press the [OFF] button of the set, and the test mode is made
clear. At this time, the memory of the tuner is initialized.
6. The power supply code is removed and the power supply is
turned off, and the power supply will be turned on again in one
minute. At this time, the tuner preset, and EQ3 setting value,
etc. are initialized.
RELEASING THE DISC SLOT LOCK
The disc slot lock function for the antitheft of an demonstration
disc in the store is equipped.
Releasing Procedure :
1. Power supply is turned off.
2. Enter the Jog daial to the left, and enter the Jog daial to the
right, and press the [1]
t
[2] ([2] is pressed for two seconds)
button of the set sequentially, and disc slot is unlocked.
SECURITY
To lock the personal information in the following menus by setting
a 4-digit password.
“Dialed Calls,” “Received Calls,” “Phonebook,”
“Preset Dial,” “Receive PB”
If you set the security, “Security Locked” appears when the above
menus are operated.
To unlock the security, select “Unlock” and input the password
number.
TEST DISCS
Use following TEST DISC whan this set con
fi
rms the operation
and checks it.
3-702-101-01 YEDS-18 (for CD)
4-225-203-01 PATD-012 (for CD)
J-2502-063-1 TCD-R082LMT (for CD-R)
REPLACING THE LITHIUM BATTERY OF THE CARD
REMOTE COMMANDER
Under normal conditions, the battery will last
approximately 1 year. (The service life may be
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the
card remote commander becomes shorter. Replace
the battery with a new CR2025 lithium battery. Use
of any other battery may present a risk of fire or
explosion.
Notes on the lithium battery
• Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
D
+ side up
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.