Sony BKDS-2530, Руководство по эксплуатации

Страница: 18 / 24

6(E)
Connection and Installation
Connecting the PC Interface Unit
The connection of the computer with the CPU-252
installed to the PC Interface Unit is shown in the figure
below.
The following computer configuration is necessary to
install the BKDS-2530 and its operation software
BZS-2050:
Computer: IBM PC/AT compatible (must be able to
accept full-sized expansion cards)
Processor: 166 MHz Intel
1)
Pentium
2)
or better
OS: Microsoft Windows NT
3)
Workstation 4.0
Memory: 32 MB or more
Display
• Resolution: 1024
×
768 pixels or more
• Number of colors: 32768 or more
CPU-252 Installation and Setup
Notes
• Have the CPU-252 installed by a trained service
technician.
• Make sure the PC’s power is off when installing and
setting up the CPU-252.
For more information about removing the PC’s cover and
installing the CPU-252, please refer to the supplied
Installation Manual.
Before installing the CPU-252 board
The only setting that needs to be changed on the CPU-
252 board is the setting of the COP1 jumper. Before
installing the board, do the following.
1
From the Windows NT Start menu, select
Programs, Administrative Tools (Common), and
Windows NT Diagnostics.
2
Open the Resources tab in the Windows NT
Diagnostics dialog and check to see which of IRQ-
10, IRQ-11, IRQ-14, and IRQ-15 are not in use. If
the COP1 jumper is not set to a free IRQ, set it to a
free IRQ.
..........................................................................................................................................................................................................
1) Intel is a registered trademark of Intel Corporation.
2) Pentium is a trademark of Intel Corporation.
3) Microsoft and Windows NT are registered trademarks of
Microsoft Corporation.
Computer (rear)
CN4 CN8
PC
CPU-252
Reference video
signal
Termination
switch
a)
PC Interface Unit
50-pin remote control cable (supplied) b)
a) Set to ON when the CPU-252 is the terminating device.
b) Commercially available SCSI cables may be used.