49
Controlling Remote Cameras
Bas
ic
Ope
rat
ions
This setting can only be configured when [Iris] is set to
auto mode. Backlight compensation is disabled when
[Iris] is set to manual mode.
Automatically adjusting the white balance
under the current conditions
Tap the [One Push] button for [AWB] (auto white
balance).
This function can be used when [White Balance] is set to
[One Push] in the [Camera Settings] screen (page 49).
When you tap [One Push], the white balance will be
adjusted according to the current subject of the image.
After doing so, view the results of automatic adjustment
and check that the white areas of the video are correct in
the [NEXT] viewer.
Configuring camera settings
1
In the [Camera] screen, tap
.
The [Camera Settings] screen appears.
2
Configure each item.
[Pan Reverse] / [Tilt Reverse]:
Use these functions
to correct the reversal of up, down, left, and right
movement that occurs when the camera is
installed upside down on a ceiling, for example.
Select [On] to reverse up, down, left, and right
movement, and select [Off] to enable normal
movement.
If you change the [Pan Reverse] and [Tilt
Reverse] settings, be sure to save the settings to
[Preset_1] in the [Camera] list. The unit starts
with the settings that are saved to [Preset_1]. If
you do not save the settings to [Preset_1], the
settings will revert to previous values.
[White Balance]:
Select one of the following white
balance modes.
•
[Auto]:
Automatic adjustment.
•
[Indoor]:
Indoor mode.
•
[Outdoor]:
Outdoor mode.
•
[One Push]:
Forcibly draw out whites from the
lighting condition of the subject, and use this
condition during shooting. [AWB] in the
[Camera] screen is only enabled when [One
Push] is selected here.
•
[Manual]:
Manual adjustment.
[R Gain] and [B Gain] adjustments are only
enabled when [Manual] is selected here.
[R Gain]:
Drag the slider to adjust the red gain.
[B Gain]:
Drag the slider to adjust the blue gain.
3
When you finish configuration, tap
.
The [Camera] screen appears again.
Resetting remote cameras
When you want to change the VISCA ID for cameras and
reestablish connections to cameras, tap [Reset Camera] in
the [Camera Settings] screen.
Depending on the camera model, the pan and tilt may
return to their default positions. When you use the [Reset
Camera] function, connection will be reestablished for all
cameras connected for VISCA control.
Saving Adjustments as Presets
Up to 16 presets can be saved for each camera.
1
In the [Input] list, select the camera input source you
want to control and display its video in the [NEXT]
viewer.
The [Camera] tab appears in the sub screen.
2
Tap the [Camera] tab to display the [Camera] screen,
and perform pan/tilt, iris, zoom and other operations.
Tip
Tip
Содержание AWS-750
Страница 121: ......
