19
H
ook
up
s and
Se
tti
n
gs
Step 3: Connecting the
AC power cord (Mains
Lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal of the recorder.
Then plug the recorder and TV AC power
cords (mains leads) into the mains. After you
connect the AC power cord (mains lead),
you must wait for a short while before
operating the recorder.
You can operate
the recorder once the front panel display
lights up and the recorder enters standby
mode.
If you connect additional equipment to this
recorder (page 23), be sure to connect the
AC power cord (mains lead) after all
connections are complete.
Step 4: Preparing the
Remote
You can control the recorder using the
supplied remote. Insert two R6 (size AA)
batteries by matching the
3
and
#
ends on
the batteries to the markings inside the
battery compartment. When using the
remote, point it at the remote sensor
on
the recorder.
b
• If the supplied remote interferes with your other
Sony DVD recorder or player, change the
command mode number for this recorder
(page 73).
• Use the batteries correctly to avoid possible
leakage and corrosion. Should leakage occur, do
not touch the liquid with bare hands. Observe the
following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an
extended period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid
inside the battery compartment, and insert new
batteries.
• Do not expose the remote sensor (marked
on
the front panel) to strong light, such as direct
sunlight or a lighting apparatus. The recorder
may not respond to the remote.
• When you replace the batteries of the remote, the
code number and Command Mode may be reset
to the default setting. Set the appropriate code
number and Command Mode again.
to mains
to AC IN
1
2
,
continued
