SonoSite C1.9 PLUS, Руководство по обслуживанию

Страница: 36 / 98

28 C1.9 PLUS Ultrasound System Service Manual
4.6.1.1 Displaying the System Information Screen
To display the system information screen:
1. Press and release the Function key.
2. Press and release I . The system information screen displays (Figure 4.5).
The system information screen displays the following information: the Boot/PIC
Vers (version), the ARM/DSP Vers, the PCBA Serial No (number), the Product
Name, the Status, the PLD 1, 2, Vers, CPLD SH Ver, SHDB Ver (scanhead
database version), and the Sh Serial No (scanhead serial number).
Note: The software versions on your system may vary based on your upgrade
and configuration
.
Figure 4.5 System Information Screen
To display the license update screen:
1. On the system information screen, select the unlock icon (upper left corner of
the screen).
The license update screen displays.
2. Perform the steps in Section 4.6.1, Installing A License Key, on page 26.
4.7 Checking and Charging the Battery
To check the battery:
Note: Disconnect the system from AC power before checking the battery charge.
Five LEDs (light-emitting diodes) on the right side of the system monitor allow you
to check the battery condition. If all LEDs are lit, the battery is fully charged. A solid
dark gray battery icon in the lower right portion of the system display indicates a low
battery. A solid white battery icon indicates approximately 10 minutes of battery life
remaining. A flashing white battery icon indicates approximately 2 minutes of
battery life remaining.