SonoSite C1.9 PLUS, Руководство по обслуживанию

Страница: 31 / 98

Chapter 4: Setup and Operation 23
To turn off power:
1. Press and hold the Power switch.
You will hear the system emit two sets of “high-low” beeps. The system powers
off after the second set of beeps.
2. Release the Power switch.
To wake up the system:
• The system has a sleep delay, which is activated through the sleep delay system
setup. When the battery charge indicators are blinking, but the other system
lighting is off, press any system control to wake up the system.
4.3 Installing and Removing the Battery
The battery comprises six lithium-ion cells (two sets of three connected in series)
plus electronics, a temperature sensor, and the battery contacts. When in use, it is
inserted into the system.
WARNING:
`
If you are holding the system, when you remove the battery, place your hand
beneath the battery. If it falls to the floor, it could be damaged, or cause personal
injury.
If the battery is being installed for the first time, it will need to be charged. Make
sure to remove the protective tape from the battery contacts before charging the
battery.
To install the battery:
1. Locate the battery compartment at the bottom of the system (Figure 4.2).
2. Install a new battery (label side up) into the battery compartment by pushing it
into the compartment until it clicks in place. (Do not force the battery into the
compartment, check the battery orientation if it is difficult to install.) Ensure that
both sides of the battery are fully connected and that the battery release button is
not pressed.
Figure 4.2 Inserting the Battery