SonoSite C1.9 PLUS, Руководство по обслуживанию

Страница: 30 / 98

22 C1.9 PLUS Ultrasound System Service Manual
4. Press the latch down until it snaps into place, securing the transducer connector
to the system.
Figure 4.1 Connecting the Transducer
To remove the transducer:
1. On the transducer connector, pull the latch up and rotate it clockwise until it
snaps to a stop (Figure 4.1).
2. Carefully pull the transducer connector away from the system.
4.2 Turning the System On and Off
When turning power on or off, you must push and hold the Power switch for
approximately one second before the system responds. This feature prevents battery
discharge, resulting from accidentally turning the system on. It also prevents
accidentally turning the system off during an exam.
The first time you turn on the system, set the date and time. See the
SonoSite
Ultrasound System User Guide.
CAUTION:
`
Do not use the system if an error message appears on the image display. Note the
error code. Call SonoSite or your local representative. When an error code occurs,
turn off the system by pressing and holding the power switch until the system
powers down.
To turn on power:
1.
Locate the Power switch on the back of the left side of the system handle. See
Figure 3.2, SonoSite Ultrasound System Controls, on page 14.
2. Press and hold the Power switch until the system beeps or until you see the
image display.
3. Release the Power switch.
Transducer connector Transducer connector latch