Sonoro STREAM SO-411, Руководство по эксплуатации

Страница: 86 / 136

86 © sonoro audio GmbH 2022
18 Troubleshooting
Malfunctions can occur with any electrical equipment. This is not necessarily due
to a defect. As such, you should check the following table to see if you can
eliminate the problem yourself.
Malfunction Possible cause Solution
No power
Power cable is not
properly connected.
Connect the power
cable properly.
No response from
STREAM
There is an error in the
STREAM.
Disconnect and
reconnect the power
plug. Then turn STREAM
on again.
Remote control does
not work, or only works
sporadically
Distance to STREAM is
too large.
Reduce the distance
between the remote
control and STREAM.
Battery is empty. Replace the battery.
No sound or poor
sound
Sound is turned off. Adjust the volume.
Headset is plugged in.
Pull the headset out of
the jack.
STREAM is not set to
the correct playback
mode.
Select another
playback mode.
FM/DAB or Internet
reception is poor.
Extend/adjust the
FM/DAB antenna or
check the Wi-Fi
connection.
There is radio
interference.
Keep STREAM away
from other electronic
devices.
Alarm does not work.
Alarm is not activated.
Activate the alarm.
Alarm volume is set
too low.
Increase the alarm
volume.
Insufficient Wi-Fi signal
strength
The router is too far or
blocked.
Place STREAM closer to
the router or adjust the
position of the Wi-Fi
antenna.