STEP 1
A. ON A FLAT PROTECTED SURFACE PLACE CROSS
BASE BOTTOM BAR (D). PLACE CROSS BASE TOP
BAR (C) INTO CROSS BASE BOTTOM BAR (D) BY
ALIGNING THE CENTER NOTCH.
B. PLACE LOWER POLE (B) ONTO CROSS BASE.
ALIGN THE BOLT HOLES IN BASE (C&D) AND LOWER
POLE (B). SECURE LOWER POLE (B) USING BOLTS (J)
AND WASHERS (K). TIGHTEN COMPLETELY USING
WRENCH (L).
ASSEMBLY INSTRUCTIONS (CONTINUED)
SONOMA OFFSET SOLAR UMBRELLA ASSEMBLY INSTRUCTIONS
STEP 2
A. PLACE BASE BOTTOM (F) ONTO THE CROSS AS
SHOWN. TAKE A SECOND BASE BOTTOM (F) AND
PLACE ONTO CROSS BASE. CONNECT THE LEDGES
AND GROOVES OF THE BASES. REPEAT FOR OTHER
TWO BASE BOTTOMS (F).
B. FILL TANKS COMPLETELY WITH WET SAND.
C. TAKE TWO BASE TOP (E) PIECES AND TURN
UPSIDE DOWN ON A FLAT PROTECTED SURFACE.
INSERT THE PLASTIC WING NUT (I) ON ONE BASE
TOP (E) THROUGH THE HOLES IN THE SECOND BASE
TOP (E). CONNECT THESE BASE TOPS (E) USING THE
PLASTIC WING NUT (I).
E. REPEAT PROCEDUE WITH OTHER BASE TOP (E)
PIECES UNTIL THE BASE TOP (E) IS ONE PIECE.
F. CLOSE THE TANK BY PLACING THE BASE TOP (E)
ONTO THE FILLED BASE BOTTOM (F). ROTATE BASE
TOP (E) UNTIL IT SITS FLAT ON THE BASE BOTTOM
(F). PLACE THE FUNNEL (H) OVER THE LOWER POLE
(B) AND INTO THE CENTER OF THE BASE TOP (E).
Page 2/4
