User’s Guide
4.4 Green View Function
At any time during play, users can press the ‘
Green View Button
’ to get a
close-up view of the putting green. Press the ‘
Green View Button
’ again to
go back to the previous page.
Important: Green View function will be activated only after selecting a
course and a hole.
4.5 Mark Function
The Mark function is used to measure distance of each shot. After hitting a
shot, press the ‘Start’ button and proceed to the ball. The distance figure stops
after pressing ‘End’. The display then shows the distance of the actual shot.
Note: The user does not have to travel in a straight line to the ball. The
distance shown on the display is always the straight line distance from where
the ‘Start’ button was pressed.
The Mark Function can be used anytime, except when the ‘Green View’
function is activated. This can be done in two ways:
1.
Press ‘
Mark
’ button (Left side key) directly.
2.
Select Mark Function icon on the ‘
Main
’ page.
Important: This function can only be activated when there is GPS
reception.
This document is the property of Sonostar Inc. Any unauthorized reproduction is prohibited.
21
