Parker Motor Maintenance Manual
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
© 2021 SONNY’S The CarWash Factory
®
. All Rights Reserved.
SonnysDirect.com
This document is confidential and proprietary to SONNY’S and cannot be used, disclosed, or published without prior written consent.
Content, prices, and availability subject to change without notice.
Manual-M, Parker Motor Maintenance
– Part # 10014125-B
Page 5 of 14
•
WARNING: Possible wet floors and slippery conditions! To avoid an accident that might
result in personal injury, death or dismemberment, all personnel MUST proceed with
Caution.
•
WARNING: Do NOT enter the wash tunnel when the equipment is operating. Personal injury,
death and/or dismemberment may occur.
•
WARNING: Make sure the proper Chemistry (Brush Lubrication) is being used in the Car
Wash Tunnel to prevent vehicle and/or equipment damage.
•
WARNING: If the Equipment Installation Dimensions at the time of installation are NOT
measured correctly, it may result in equipment damage and/or failure. Dimensions MUST be
verified if equipment is already installed. Contact
Sonny’s Technical Support Team at 1-800-
327-8723, Ext: 234 for any Installation questions.
•
WARNING:
All connections and repairs
MUST ONLY
be performed by Licensed Professionals.
Perform all trade work in compliance with all applicable local and national codes.
•
WARNING:
Although building codes have been considered in developing all drawings, verification
of site-specific conditions and compliance with federal, state, and local building codes is the
exclusive responsibility of the customer and/or architect and engineer.
•
WARNING:
Do
NOT
attempt to repair or adjust any pressurized liquid or pneumatic part, hose,
pipe, or fitting while that equipment is in operation.
•
WARNING:
Do
NOT
operate any equipment that requires safety covers with those covers removed
or improperly installed. Do
NOT
operate any equipment if any component of that equipment is
suspected to be defective or malfunctioning.
•
WARNING: Store all cleaning, washing solutions and oils in a well-ventilated area.
Clean up
fluid spills immediately to prevent hazardous safety conditions. Be certain to follow all
safety procedures on SDS Sheets for each chemical product used.
•
WARNING: When a piece of equipment must be in operation during inspection or
maintenance, one qualified technician must stay at the power disconnect switch while
another qualified technician performs the inspection or maintenance.
•
WARNING:
All Equipment MUST be given regular maintenance to prevent equipment
damage and/or failure that will VOID the warranty.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS AND WARNINGS
