IP iBase Standard and iCLASS Enhanced Keypad
19810016 REV C
Page 2
1.3.1 Numerical Buttons
The Numerical Buttons are used to enter any numerical values when prompted via the LCD menu.
1.3.2 LED Status Indicators
The LED on the right side of your keypad changes colors depending on your system status. It
flashes when there is an alarm no matter what color or arm state.
RED: System is ON (Armed)
GREEN: System is OFF (Disarmed)
YELLOW: Occupied Security Level
Flashing LED: An alarm has
occurred
Note: A beeping keypad indicates that the system is in alarm or incapable of reporting alarms.
Keypad beeping sequence:
Seconds On Seconds Off Alarm Type
0.125
0.125
Valid Request at Keypad (3 beeps annunciated)
1.250
0.750
Loss of communications
3.000
3.000
Aborted Alarm (occurs after loss of communications)
0.125
4.875
Loss of Battery Power
Always
N/A
Burglar Alarm
2.750
0.250
Tamper (e.g. Security Cabinet door opened)
0.125
2.875
Trouble Alarm
1.3.3 SELECT Button
The Select Button is used to access the system menus.
1.3.4 TEST Button
Initiates communications between the iBase or FlexiBase Panel and the Central Station. Only active
from the default screen (Disarm state screen).
1.3.5 ARM/DISARM Button
This button is used when arming or disarming the system.
1.3.6 ENTER Button
Enter your code directly from the default screen then press the Enter Button to access menus, arm,
and or silence alarms. Also used to complete a menu selection or entry of an Access Code.
1.3.7 Navigation Buttons
The Navigation Buttons are used to scroll System Menus up and down. The left navigation button
also acts as a clear or backspace button.
1.4 Security Levels
There are three security levels available on your system. They are: Armed, Occupied, and
Disarmed.
•
Armed: This is selected to arm your security system and monitor all devices. The protected
area should not be occupied.
