SONIQ CWR150NS-AU, Инструкция по эксплуатации, Страница: 77 / 90

- 76 -
The procedure for manipulating a mapping group is as follows:
Step 6 Select Enable to enable this function.
Step 7 Select a group from the table.
Step 8 Select interfaces from the WAN and LAN interface list and add them to
the grouped interface list using the arrow buttons to manipulate the
required mapping of the ports.
Click Apply Changes to save the changes.
3.6.4 QoS
Choose Advance > QoS , the page shown in the following figure appears. Entries
in the QoS Rule List are used to assign the precedence for each incoming packet
based on physical LAN port, TCP/UDP port number, source IP address, destination
IP address and other information.
Step 1 Enable IP QoS and click Apply to enable IP QoS function.
Step 2 Click add rule to add a new IP QoS rule.
The page shown in the following figure appears.