Sonik ARMATEK 60 BROLLY, Руководство пользователя

Страница: 2 / 6

Thank you for purchasing the Sonik ARMATEK 60 Brolly. We hope that you have many happy fishing trips using it.
Please take a few moments to read through this manual. It contains advice on the use and care of your new shelter.
ASSEMBLY
We recommend setting up your brolly for the first time prior to your fishing trip to ensure you are familiar with all the
components and setup process outlined below;
Remove the groundsheet from its sleeve and place on the ground. It will act as a useful pegging guide and help to keep your
brolly clean. The Sonik badge is located at the front and groundsheet clips at the rear. Clips and elastic pegging points are
located on it’s underside.
1)
Open the brolly, ensuring that the locking button clicks into place. We recommend that until you are familiar with the system it
is best to setup the brolly without the front panel attached.
2)
Line up the brolly with the back of the groundsheet, peg out the back 5 pegging points to hold the brolly in place whilst you
attach the front poles.
3)
Fully unfold the front pole sections and connect to form an arc. Clip the front pole into place using the three central internal clips
shown in photo.
4)
Extend the ends of the front pole and locate into the front corner eyelets. The Cam-locks can be tightened by turing the
cam-lever clockwise. Peg out the front corners selecting from the multiple height pegging points. Extend the front pole ends to
tension the fabric.
5)
Unscrew the centre pole and replace with locking screw found in the end of the centre pole.
6)
Unfold and connect the side bars together, thread the double thumbscrew end of the pole through the sleeve in the top of the
side pocket organiser. Attach the side pole to the front pole junction and tighten the two thumb screws to hold it in place.
7)
Clip the corner of the side pole into place. Locate the free end into the skirt webbing eyelet. Extend and tighten to tension the
canopy. Secure the side organiser using the four corner straps.
8)
If required, now zip on the front panel, this has two zip sliders one at each end. Peg the front panel down with the door closed.
If the panel is tight/loose adjust the span of the front bar.
9)
Fit the groundsheet by clipping into place at the back of the brolly and peg out the front elastic points with the pegging points
of the brolly front panel. The groundsheet should lie on top of the brolly skirt material.
10)
The brolly is supplied with four spacer bars. These can be located at the bottom of both front and back vents to allow airflow
whilst also keeping the vents waterproof.
11)
SETUP INSTRUCTIONS SETUP INSTRUCTIONS
1
1
2
3
4
5
6
7
8
9
2