Adjusting the sound
9
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• ON or OFF will appear on the display.
Turning the filter on/off
① While pressing
, press
.
Depending on the on/off status, the
LED is lit/
unlit.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The filter type/OFF is shown on the display.
Changing the filter type
① While pressing
, press a FILTER button.
The LED will light for the selected filter type.
(For BPF, both and
LEDs will light red.)
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• To select BPF, press and
at the same time.
• The filter type name is shown on the display.
• Three types of filters can be selected.
1.
LPF : Filter the cuts high frequencies
2.
HPF : Filter that cuts low frequencies
3.
BPF : Filter that only allows through frequencies
in the specified band
Changing the filter cutoff frequency
① Turn the
CUTOFF/speed
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–127.
• The frequency can be changed in a range of 70–
21600Hz.
Adjusting the filter resonance
① Turn the
RESO/shift
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• For BPF, this adjusts the width of the band.
• The adjustment range is 0–127.
• The resonance can be changed in a range of 0.1–10.
• For BPF, the bandwidth can be changed in a 0.1–2.0
octave range.
Adjusting the LFO speed
① Turn the
RATE/speed
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The LFO produces a sine wave.
• The adjustment range is 0–127.
• The frequency can be changed in a range of 0.1–30
Hz.
Adjusting the amount of LFO effect on
pitch
① Turn the
PITCH/amount
knob
.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–127.
• This changes it in a range of 0–2 octaves.
Adjusting the amount of LFO effect on fil-
ter cutoff
① Turn the
FLTR CO/reverb
knob.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• The adjustment range is 0–127.
Adjusting the envelope generator
① Turn the
ATTACK/decay
and
RELEASE/sus-
tain knobs.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The parameter is shown on the display.
• To change the decay and sustain, turn the
AT-
TACK/decay
and
RELEASE/sustain
knobs
while pressing and holding
.
• The adjustment range is 0–127.
• ATTACK, decay and RELEASE can be set in time
ranges of 0–5000 ms.
• The level set by sustain is 0–100%.
