SonicWall Switch Getting Started Guide
Configuring from the Firewall
27
Adding a Switch to a Firewall Manually
Once an IP address is established as described in
Adding a Switch to a Firewall Manually
, only a few
steps are necessary to set it up for management from a firewall.
To Connect Switch to Firewall:
1 Connect an Ethernet cable (that is, RJ45 to RJ45) from a port on the Sonic Switch to an available port on
the firewall.
2 Login to the management console and navigate to
MANAGE | System Setup > Switch Controller
and
note the Switch-related pages. From Overview click on
Add Switch
as shown below.
3 Click on
Switch
and when the Switch List appears click on
Add Switch
. The dialog box will appear:
• ID
: The system will auto-assign a consecutive number here.
IMPORTANT:
Please register your Switch before trying to add it to a firewall. See
.
NOTE:
When adding a Switch manually, first check that it is configured to factory defaults. This can
be ensured by depressing the reset switch for 10 seconds or more. The Switch can also be factory
defaulted from the Switch Local UI, or the Command Line Interface accessible through the console
port.
NOTE:
To change the Reserved VLAN range on the firewall, do so before adding the SonicWall
Switch. If the Reserved VLAN range changes after connecting the Switch, then the Switch must be
removed and re-added.
NOTE:
If the above options do not appear, check that your firewall and Switch are at the correct
firmware release levels.
Содержание SWS12 Series
Страница 1: ...SonicWall Switch Getting Started Guide...
