SonicWALL SuperMassive 9200, Руководство по началу работы

Страница: 14 / 73

14 SonicWall SuperMassive 9200/9400/9600 Getting Started Guide
Determining the WAN Type
Before configuring your SonicWall SuperMassive appliance,
you need to determine the type of WAN connection that your
setup will use. SonicWall supports the following types:
• Static —Configures the appliance for a network that uses
static IP addresses.
• DHCP —Configures the appliance to request IP settings
from a DHCP server on the Internet.
• PPPoE —Point ‐ to ‐ Point Protocol over Ethernet (PPPoE) is
typically used with a DSL modem. If your ISP requires
desktop software with a username and password, select
NAT with PPPoE mode.
• PPTP —Point ‐ to ‐ Point Tunneling Protocol (PPTP) is used to
connect to a remote server. PPTP typically supports older
Microsoft Windows implementations that require
tunneling connectivity.
• L2TP —Layer 2 Tunneling Protocol (L2TP) is used to transmit
Layer 2 data over IP or other Layer 3 routed networks.
Internet Service Providers (ISPs) often use it to enable
virtual private networks (VPNs) for customers over the
Internet. It does not encrypt network traffic itself. If L2TP is
not available in the Setup Wizard, you can configure it later
in the SonicOS management interface.
System Requirements
Before beginning the setup process, verify that you have:
• An Internet connection
• A Web browser supporting Java Script and HTTP uploads
NOTE: For more information regarding other supported
WAN types such as Wire Mode or Tap Mode, refer to the
SonicOS Administration Guide .
Supported Browsers
Accepted Browser Browser Version Number
Internet Explorer 9.0 and higher
Chrome 18.0 and higher
Firefox 16.0 and higher
Safari 5.0 and higher, running on
non ‐ Windows machines