SonicWALL SSL-VPN 4000, Руководство по началу работы

Страница: 6 / 62

SonicWALL SSL-VPN 4000 Getting Started Guide Page 5
Applying Power to the SonicWALL SSL-VPN 4000
1. Plug the power cord into the SonicWALL SSL-VPN 4000 and into an appropriate
power outlet.
2. Turn on the power switch on the rear of the appliance next to the power cord.
The Power LED on the front panel lights up green when you turn on the
SonicWALL SSL-VPN 4000. The Test LED lights up yellow and may blink for up
to a minute while the appliance performs a series of diagnostic tests. When the Test
light is no longer lit, the SonicWALL SSL-VPN 4000 is ready for configuration.
If the Test or Alarm LEDs remain lit or if the Test LED blinks red after the
SonicWALL SSL-VPN 4000 has booted, restart the SonicWALL SSL-VPN 4000. For
more troubleshooting information, refer to the
SonicWALL SSL-VPN Administrator’s
Guide .
Continue to Step
2
Console Port : Provides
Power LED
Alarm LED
Test LED
X1 - X5 : 10/100 Ethernet
X0 : Default management port.
Provides connectivity between
the SSL-VPN and your gateway.
Exhaust fans Power supply fan
Power plug
Power switch
access to the command
line interface.
(for future use)
3