SonicWALL NSA 2400, Руководство по началу работы

Страница: 21 / 70

Page 20 Initial Setup
Connecting the LAN Port
1. Connect one end of the provided Ethernet cable to the
computer you are using to manage the
SonicWALL NSA Series.
2. Connect the other end of the cable to the X0 port on your
SonicWALL NSA Series.
The Link LED above the
X0 ( LAN ) port will light up in green
or amber depending on the link throughput speed,
indicating an active connection:
- Amber indicates 1 Gbps
- Green indicates 100 Mbps
- Unlit while the right (activity) LED is illuminated
indicates 10 Mbps
Applying Power
1. Plug the power cord into an appropriate power outlet.
2. Turn on the power switch on the rear of the appliance next
to the power cords.
The Power LED on the front panel lights up blue when you plug
in the SonicWALL NSA. The Alarm LED may light up and the
Test LED will light up and may blink while the appliance
performs a series of diagnostic tests.
When the Power LEDs are lit and the Test LED is no longer lit,
the SonicWALL NSA is ready for configuration. This typically
occurs within a few minutes of applying power to the appliance.
Note:
If the Test or Alarm LEDs remain lit after the
SonicWALL NSA appliance has been booted, restart
the appliance by cycling power.
Accessing the Management Interface
The computer you use to manage the SonicWALL NSA Series
must be set up to have an unused IP address on the
192.168.168.x/24 subnet, such as 192.168.168.20.
To access the SonicOS Enhanced Web-based management
interface:
1.
Start your Web browser.
Note:
Disable pop-up blocking software or add the
management IP address http://192.168.168.168 to your
pop-up blocker’s allow list.
To power
source
I
o