TIP ASSEMBLY (CV52)
If the tip is not already assembled, follow the instructions below as applicable.
TIP REPLACEMENT (CV52)
1. Clean the mating surfaces, as well as the threaded stud and hole. Check
that the stud is tight (see recommended torque requirements on page 13).
2. Hand assemble the tip to the titanium driver using open-ended wrenches
as shown below. Tighten securely.
Do not force or overtighten.
HORN ASSEMBLY (CV54 ONLY):
1. Clean the mating surfaces of the converter and horn, as well as the
threaded stud and hole. Check that the stud is tight (see recommended
torque requirements on page 13).
2. Hand assemble the converter and horn together using open-ended
wrenches as shown below. Tighten securely.
Do not force or overtighten.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
12
I N S T R U C T I O N M A N U A L • M O D E L H 5 2 0 / H 5 4 0
Never remove or install
a tip by holding the
hand gun case or
rotating the tip with
only one wrench as
this may cause
damage to the booster
and/or converter.
CV54 / HORN
CV52 / TIP
NOTE:
Before using
wrenches to assemble
as shown, you should
be able to seat the
horn or tip without
encountering
resistance in the
mating threads.
Содержание H520 T/E
Страница 1: ...Models H520and H540 Hand Held Welders I N S T R U C T I O N M A N U A L Sonics Materials Inc...
Страница 3: ...2 I N S T R U C T I O N M A N U A L M O D E L H 5 2 0 H 5 4 0...
Страница 32: ...I N S T R U C T I O N M A N U A L M O D E L H 5 2 0 H 5 4 0 31 APPENDIX DB9 I O CONNECTIONS DIAGRAM...
