25
24 / 45
GB
III. INSTRUCTIONS FOR USE
Remove all packaging materials and take out the appliance and any accessories.
Parts which come in contact with the oral cavity must be rinsed in warm drinking
water before first use.
CHARGING THE BRUSH
This appliance is equipped with a contactless (induction) charging system which
works on the principle of energy transfer through an electromagnetic field.
No direct connection with the power cable is required which makes charging
more convenient and thanks to the enhanced insulation (IPX7) also safer.
Connect the charging base (
C
/
D
) to the mains first and place the brush body (
A
)
onto the cylindrical projection in the charging base. Charging is indicated by the
charging indicator (
A3
). For a full charge, the battery needs to be charged for
approximately 10 hours. Depending on the cleaning mode used, a fully charged
battery will provide approximately 2-3.5 hours of operation which corresponds
to about 1-2 months when used twice a day for two minutes.
Note: Although the brush should not be charged before it is fully
discharged, we recommend charging it at regular intervals
(e.g. after 2-3 weeks of use) in order to ensure optimum battery life.
Caution
– The charging indicator light (
A3
) is on even when the battery is fully charged.
It does not indicate that charging is finished.
– When charged for the first time, or if the appliance was not in use for more
than 3 months, it needs to be charged for 24 hours.
–
Do not exceed the recommended time of charging during regular
charging!
– The charging base also serves as a stand where you can place the brush
after use. However, do not connect it to the mains unless you wish to charge
the brush or disinfect the brush heads with UV light. Do not leave the charging
base connected to the mains permanently!
– The appliance warms up during charging, but this is normal and not a defect.
– The operating time is only approximate. The time depends on the condition
of the battery, ambient temperature, age, method of charging, etc.
USE
Before use, slide the brush attached onto the brush body (
A
) to connect them
(See Fig. 1). A small gap will remain between the brush body (
A
) and the coloured
ring (
B2
) which is not a defect. To remove the brush head, proceed the other way
round. Do not switch on the appliance without the brush attached!
Moisten the brush and apply a small amount of toothpaste on it.
Содержание Eta 3707
