7
T RA N SP OR T S ET -U P
OPERATION OF THE TRANSPORT 3
Before plugging in the Transport 3, check to see that the unit is
configured for the correct AC line voltage for country of use. The
operating AC line voltage is indicated on the side of the shipping
box. If the Transport 3 is set incorrectly for the country in which it
is to be operated, contact the dealer or distributor in your area. If
the unit is configured properly, continue with operation.
Connect the Detachable Power Cord to the Transport 3 chassis
(see Figure 5) and plug your Transport 3 into the AC power
source.
Load the Remote Control with 2 AA size batteries.
Next choose the most appropriate digital output connector (K
through O). With the appropriate cable connect the Transport 3 to
your DAC’s digital input.
The Transport 3 CD Turntable is now ready for operation. Power
the unit by pressing the Power Button (B), load the Transport 3 with
a favorite CD, place the CD clamp over the center of the CD and
close the IRIS hatch. Select desired track(s) and press the Play
Button (G or 2 on the remote). You are now ready to sit back, lis-
ten and enjoy.
BREAK-IN TIME
As with all audio electronic products, the ultimate sonic character
of the Transport 3 will not be realized until and unless the unit
receives a minimum of approximately 150 hours of signal break-
in time (i.e. the Transport 3 is on and outputting a signal).
T R O U B L E S H O O T I N G
If at any time the Transport 3 fails to work properly, consult this
c h e c k l i s t :
If the Transport 3 will not turn on:
1. Check that the Power Switch (B) is in the on position.
2. Check that the AC Detachable Power Cord is plugged into the
Transport 3 Detachable Power Cord Socket (I) and is connected to
a live source of AC power. For instance, if using a power bar,
check that the bar is turned on.
If the Transport 3 is operating but does not play:
1. Be sure the rest of the system is functioning properly (i.e. DAC,
power amplifiers, cables and connections, etc.).
2. Check that the loading drawer is not jammed by an improperly
loaded CD.
3. Check to ensure the CD has not been put in the transport with
the label side down.
4. Be sure the CD is not damaged and is readable.
If the remote does not function, check to ensure that the two AAA
batteries are fresh.
If these checks fail to correct the operation of the Transport 3
Transport contact the nearest Sonic Frontiers dealer or Sonic
Frontiers directly.
Figure 5
- Align socket pins to corresponding holes and push together.
I
