Adjusting The Snooze Time
The default snooze time setting is 9 minutes but you may adjust the snooze time between 1
minute and 30 minutes as desired. To adjust the snooze time:
•
Press and hold the
SNOOZE Button (8)
for four seconds. The clock display will show
the default snooze time ‘9’. Release the snooze button
•
Press the
“SLOW“ Button (7)
to adjust the snooze time to the desired setting, from 1
minute to 30 minutes.
•
When the display is showing the desired snooze time, it will return to the normal clock
mode after 3 seconds. The new snooze time setting becomes the new default and
remains in the memory until you change it again.
Shutting Off the Alarm –
Alarm can be shut off temporary for the day or permanently shut off.
1) When alarm goes off, press the
“ALARM SET/OFF“ (5)
button to turn off for the day and
come back on at the same time the next day, if alarm settings have not changed.
2) To shut the alarm off permanently, slide the
“ Alarm Mode Switch“ (11)
down to the OFF
position. The alarm will not come on until the
“ Alarm Mode Switch“ (11)
is set to
“VIB/BUZZ“, “VIB“, or “BUZZ“ position.
NOTE: The Alarm Off function of Alarm 1 and Alarm 2 is independent of each other.
Dimmer Operation
There is a 5-level brightness control for the LED display. Press the SNOOZE button once to
change the display brightness. The brightness will cycle from 5-4-3-2-1-2-3-4-5 (from bright to dim
then from dim to bright).
*NOTE*
: The dimmer function will not work, when the clock is in snooze mode.
Volume Control –
1) To adjust the volume, rotate
VOLUME wheel (12)
located on the lower right corner of the
clock.
Tone Control –
1) To adjust the TONE, turn the
TONE wheel (10)
located on the top right corner of the clock.
Bed Shaker / Vibrator –
1) Attach the bed shaker jack to the back of clock at
“VIBRATOR INPUT“ (15)
.
2) To turn on vibrator slide
“Alarm Mode Switch“ (11)
to “VIB/BUZZ“ or “VIB“ position.
3) Place vibrator between mattress and box spring.
Bed Shaker / Vibrator Strength Control
Slide the
Vibrator Strength switch (2 )
to adjust the vibrator strength, Hi setting is the
stronger and the Lo setting is the weaker.
Battery Backup –
To use the battery backup, you can install a 9-volt alkaline battery in the back of the clock located
under the
Battery Compartment Cover (17).
The battery needs to be purchased separately.
Note the LED display will not show during power failure but the clock will still be running
and keeping proper time until the power comes back
.
During a power failure, the alkaline
battery can only keep the clock IC running for up to 30 days.
(
During a Power failure, the LED
display will not show the time
.)
NOTE:
For the best results it is recommended that the battery be changed every 6 months. If the
clock is not used for a while, it is recommended to remove the battery to avoid damage to the
clock from battery leakage.
