Tone Control –
1) To adjust the TONE, turn the
TONE wheel (10)
located on the top right corner of the clock.
Bed Shaker / Vibrator –
See Figure B
1) Attach the bed shaker jack to the back of clock at
“VIBRATOR INPUT” (15)
.
2) To turn on vibrator, slide “
Alarm Mode Switch” (2)
to “VIB/BUZZ“ or “VIB“ position.
3) Place vibrator between mattress and box spring.
Battery Backup –
To use the battery backup, you can install a 9-volt alkaline battery in the back of the clock located under the
Battery Compartment Cover (16).
The battery needs to be purchased separately.
Note the LED display will not
show during power failure but the clock will still be running and keeping proper time until the power
comes back.
During a power failure, the alkaline battery can only keep the clock IC running for up to 30 days.
(During a Power failure, the LED display will not show the time.)
NOTE:
For the best results it is recommended that the battery be changed every 6 months. If the clock is not used
for a while, it is recommended to remove the battery to avoid damage to the clock from battery leakage.
DC 9V Power Input –
Attach the
“DC POWER INPUT” (14)
to the back of DC9V IN next to
“VIBRATOR INPUT” (15)
; it is the smaller
input of the two.
NOTE
: IMPORTANT: do not confuse
“DC POWER INPUT” (15)
with the
“VIBRATOR INPUT” (15)
GENERAL DATA
UL listed Power Adaptor Input: AC100-240V~, 50/60Hz
Power Consumption: Adaptor Output: DC9V
, 650mA
The Lightening flash and arrowhead
within the triangle is a warning sign
alerting you of dangerous voltage
inside the product.
CAUTION:
TO REDUCE THE RISK OF
ELECTRICAL SHOCK, DO
NOT REMOVE THE COVER
(OR BACK) FROM THE
PRODUCT. NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO YOUR
SONIC ALERT DEALER.
The exclamation mark within the
triangle is a warning sign alerting
you of important instructions
accompanying the product.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
- Attention should be drawn to the environmental aspects of battery disposal.
-
This icon indicates separate disposal for electrical and electronic equipment
.
Normal function may be disturbed by strong electromagnetic interference. If this is the
case, normal function can be resumed by simply resetting the unit following the procedure
in the instructions manual. If function does not resume, try moving the unit to another
location.
