LC-RL-8-W User Manua
l
Sonetonix
6
4. Manual Control
4.1 Programming the S-NET ID
For any communication to take place with the LC-RL-8-W, it needs to be programmed with
a unique S-NET ID (1 to 230).
The S-NET ID can be set manually using the following procedure
Step 1:
Press and hold the (1) Setup switch on front panel for 5 seconds
Step 2:
The Watch dog LED stops blinking and the device enters in to programming mode
Step 3:
The default S-NET ID will be displayed in terms of WDT LED blinking sequence.
Step 4:
Press the (2) switches on front panel to set the S-NET ID number
Step 5:
After choosing a suitable ID, press the (1) Set up Switch to enter in to normal mode, the
watchdog LED will flash a blinking sequence and enter in to Normal mode.
4.2 Changing the Channel level / status
Front panel 8 switches for control and configure the load status manually. Each channel’s
ON / OFF status is indicated on the Front panel LEDS
The load status for any channel can be changed manually by pressing corresponding tactile
switch.
