Remote Control
The remote control can be used by directly pointing at the Top Control
Panel or IR Sensor at the end of the IR Remote Sensor Wire
1)
CH: Press to scan for and preset FM radio frequencies
2)
CH+/CH-: Press to increase/decrease FM frequency by 0.1
3)
+/-: Press to increase/decrease the volume
4)
0-9: In USB/SD mode, press to select MP3 track by number. In FM mode,
press to manually enter FM radio frequency/station. For instance, you can
enter 839 for station 83.9.
Warning
Continued exposure to sound at excessively high volume may cause hearing
loss or damage. Listening to audio equipment at a high volume level while
operating a motor vehicle may impair your ability to hear external sounds
such as horns, warning signals, or emergency vehicles, thus constitute to
potential traffic hazards. Please use caution.
Mobile Audio Installation (vehicle)
Your vehicles electrical system can power your Active Speaker Box. Carefully and
correctly follow all instructions. If you do not have the technical knowledge or feel
uncertain about an installation, please consult a qualified technician or call our
customer services hotline at 877-997-7888.
Basic wiring needs:
1)
+12V: 12volt constant (power source)
2)
REM: 12volt switch wire (+12V and 0V)
3)
GND: Ground wire (negative)
4)
Audio signal
5)
Optional Cigarette lighter power plug
The Active Speaker Box can be installed as an amplified sub-woofer. Basic
amplifier installation techniques can be applied to facilitate the installation process
or as an additional reference. Connect the following wires to the power harness;
then plug the power harness into your Active Speaker Box.
1) The 12 volt constant wire can be gained directly from the battery’s positive
terminal or from the
fuse box. Directly
wiring to the battery
will simplify the install
process. If connected
directly to the battery,
place a fuse within 16
inches of the
connection for safety
purposes.
2) The 12 volt switch
wire (REM) can be
attached from rear of
the radio (aftermarket)
or from an accessory
wire in the vehicles
electrical system. The
RED wire connected to
the back of the
NONFACTORY
(aftermarket) radio is
4
5
6
