A SSEM BLY I N ST RUCT I ON
The bed is composed of several
components: The headboard, foot
board, side rails, bed slats and
support slats. Determine the
intended location and ensure there is
enough space to work with and fully
read these instructions before
physically doing the entire assembly.
STEP #1:
Place the headboard upright in the
position you wish the bed to be in
when fully assembled. The
headboard bed fast hardware should
be facing inside, toward the mattress.
Secure the threaded rod (1) to the
fixed nut in the headboard (A) by
simply turning it manually. Raise the
side rail (B) up and place the rod (1)
to align with the bore holes on the
end of the side rails (B). Put the side
rails (B) up against the headboard
(A) so the threaded rods (1) go
through the bore holes. Insert curved
washer (2), lock washer (3) and
place hex nuts (4) on threaded rod
(1) then tighten the hex nuts (4) with
wrench (5) provided, as illustrated in
FIGURE 01
.
STEP #2:
Repeat the above procedure with the
other side rail (B) to attach it to the
headboard (A), and then repeat to
connect side rails (B) to the
footboard (C).
STEP #3:
Attach the short support leg (F) to
the slat support (E) by turning it
manually, as illustrated in
FIGURE 02
.
STEP #4:
On inside face of both headboard (A)
and footboard (C) are pre-installed
metal brackets for the support slat
(E). Set the support slat (E) on the
metal brackets, as illustrated in
FIGURE 03
.
STEP #5:
On inside surface of both side rails
(B) are cavities designed to hold the
individual bed slats (D). Set
individual bed slats (D) on both
cavities of the side rails (B) as
illustrated in
FIGURE 04.
FIGURE 01
FIGURE 03
E
FIGURE 04
D
D
D
FIGURE 02
E
F
Fig.03
Fig.02
E
F
A
B
B
C
3
2
1
4
2 2
/
