background image

I n s t r u c t I o n   M a n u a l

crown

®

 amplifier

introduction

Thank you for purchasing the 

SLS

 crown amplifier. The 

SLS

 crown 

amplifier has been preloaded with custom equalization to achieve 
maximum performance from the 

SLS

 satellites and subwoofers. when 

properly installed, this amplifier will provide you with years of outdoor 
entertainment pleasure. To get the most out of your new system, 
please read this manual thoroughly before you begin installation.

amplifier power planning 

The maximum number of satellites and subwoofers that can be used 
in a system will depend on the quantity of amplifier’s available power.

Before beginning an installation use the chart below to calculate 
the amplifier power your installation will require. multiple amplifiers 
may be required in large installations.

wattage calculator

 

input connections 
Unbalanced (most common)

To connect your audio source to the crown amplifier you will need 
cables with rca connectors on the source end and bare wire on the 

SLS

 amplifier end. The crown amplifier channels are labeled cH1 

and cH2. Both channels are identical so you can choose which 
to use for right and left depending on your personal preference.

attach the bare wires from your cable to the phoenix style 
connector provided in the amplifier box. note the location of the 
positive and ground wires on the phoenix connector. You must run 
a jumper wire from the ground terminal to the negative terminal; 
see figure 1.  

Balanced

when using the 

SLS

 in a commercial installation it might be 

necessary to connect the amplifier using balanced wiring.

connect the wires from your source equipment to the phoenix 
connector. Be sure to observe proper polarity when connecting the 
wires to the phoenix connector. if your source equipment uses Xlr 
connectors please confirm the polarity or pin out of your source 
equipment before terminating the phoenix connector. See figure 2

figure 1. rca to pHoeniX connector

figure 2. Balanced lines to the phoenix connectors

NOTE: WHEN USING BALANCED INPUTS PLEASE CONSULT THE 
CrOWN

®

 AmPLIfIEr mANUAL fOr GrEATEr DETAIL.

33-5514    030713

for Technical Support, please contact Sonance

:

 (800) 582-0772

©2013 Sonance. all rights reserved. Sonance is a registered trademarks of Dana innovations.

Due to continuous product improvement, all features and specifications are subject to change without notice. 

for the latest Sonance product specification information visit our website: www.sonance.com

SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672-7531 USA

(800) 582-7777 or (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (800) 582-0772

www.sonance.com

limiTeD THree (3) Year warranTY 

Sonance warrants to the first end-user purchaser that this Sonance-brand product (“product”), when purchased from an authorized Sonance 
Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense 
during the warranty period, either repair the defect or replace the product with a new or remanufactured product or a reasonable equivalent.

eXclUSionS

To THe eXTenT permiTTeD BY law, THe warranTY SeT forTH aBoVe iS in lieU of, anD eXclUSiVe of, all oTHer warranTieS, eXpreSS 
or implieD, anD iS THe Sole anD eXclUSiVe warranTY proViDeD BY Sonance. all oTHer eXpreSS anD implieD warranTieS, 
inclUDinG THe implieD warranTieS of mercHanTaBiliTY, implieD warranTY of fiTneSS for USe, anD implieD warranTY of 
fiTneSS for a parTicUlar pUrpoSe are SpecificallY eXclUDeD.

no one is authorized to make or modify any warranties on behalf of Sonance. The warranty stated above is the sole and exclusive remedy 
and Sonance’s performance shall constitute full and final satisfaction of all obligations, liabilities and claims with respect to the product.

in anY eVenT, Sonance SHall noT Be liaBle for conSeQUenTial, inciDenTal, economic, properTY, BoDilY inJUrY, or 
perSonal inJUrY DamaGeS ariSinG from THe proDUcT, anY BreacH of THiS warranTY or oTHerwiSe. 

This warranty statement gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not allow 
the exclusion of implied warranties or limitations of remedies, so the above exclusions and limitations may not apply. if your state does not 
allow disclaimer of implied warranties, the duration of such implied warranties is limited to period of Sonance’s express warranty.

Your product model and Description: 

SLS

 crown

®

 amplifier. 

warranty period for this product: Three (3) years from the date on the original sales receipt or invoice or other satisfactory proof of purchase.

additional limitations and exclusions from warranty coverage: The warranty described above is non-transferable, applies only to the initial 
installation of the product, does not include installation of any repaired or replaced product, does not include damage to allied or associated 
equipment which may result for any reason from use with this product, and does not include labor or parts caused by accident, disaster, 
negligence, improper installation, misuse (e.g. overdriving the amplifier or speaker, excessive heat or cold or humidity, outdoor installation), 
or from service or repair which has not been authorized by Sonance. obtaining authorized Service: To qualify for the warranty, you must 
contact your authorized Sonance Dealer/installer or call Sonance customer Service at (800) 582-0772 within the warranty period, must 
obtain a return merchandise number (rma), and must deliver the product to Sonance shipping prepaid during the warranty period, together 
with the original sales receipt, or invoice or other  satisfactory proof of purchase.

 

W I R E   G A U G E   C H A R T

WIRE GAUGE

18 Gauge
16 Gauge
14 Gauge
12 Gauge

DISTANCE

Up to 100 Feet (33 meters)
Up to 150 Feet (50 meters)
Up to 250 Feet (80 meters)

Up to 600 Feet (192 meters)

NOTE: Please refer to the wiring chart below to determine 
which size wire to use over a given distance.

*The lS15SUB is a dual voice coil, single-stereo subwoofer. 
each voice coil draws 200 watts, for a combined total of 400 
watts. The lS15SUB requires a 4-conductor wire to connect 
both it’s left and right channel inputs.

model

Qty. 
ch.1

Qty. 
ch.2

x

watts

Total 
ch.1

Total
ch.2

lS47SaT

x

25

LS67SAT

x

25

lS87SaT

x

50

lS10SUB

x

100

HS10SUB

x

100

lS12SUB

x

100

LS15SUB*

x

400
Sub Total
20% Head 
room

TOTAL WATTAGE

Содержание crown

Страница 1: ...ote the location of the positive and ground wires on the Phoenix connector You must run a jumper wire from the ground terminal to the negative terminal see Figure 1 Balanced When using the SLS in a commercial installation it might be necessary to connect the amplifier using balanced wiring Connect the wires from your source equipment to the Phoenix connector Be sure to observe proper polarity when...

Страница 2: ...ectors to prevent a short circuit or shock hazard Caution The amplifier should not be connected to AC power until all connections are completed High power 70 volt amplifiers present a serious shock hazard Do not connect speaker wires to the amplifier until all other connections are completed Satellite and Subwoofer Stereo Wiring Examples SLS Wiring Diagram 70V Expandable Configuration 4 SATs to 1 ...

Страница 3: ...ess the Next Down button until the word PRESET appears on the display 3 Press the Select Enter button 4 Press the Next Down or Prev Up buttons until the preset you desire is displayed 5 Press the Select Enter button 6 Your chosen preset should now be displayed Volume Control In most systems the volume control knobs should be turned fully clockwise to achieve proper level Included in the amplifier ...

Страница 4: ...oduct IN ANY EVENT SONANCE SHALL NOT BE LIABLE FOR CONSEQUENTIAL INCIDENTAL ECONOMIC PROPERTY BODILY INJURY OR PERSONAL INJURY DAMAGES ARISING FROM THE PRODUCT ANY BREACH OF THIS WARRANTY OR OTHERWISE This warranty statement gives you specific legal rights and you may have other rights which vary from state to state Some states do not allow the exclusion of implied warranties or limitations of rem...

Отзывы: