I n s t r u c t I o n M a n u a l
crown
®
amplifier
introduction
Thank you for purchasing the
SLS
crown amplifier. The
SLS
crown
amplifier has been preloaded with custom equalization to achieve
maximum performance from the
SLS
satellites and subwoofers. when
properly installed, this amplifier will provide you with years of outdoor
entertainment pleasure. To get the most out of your new system,
please read this manual thoroughly before you begin installation.
amplifier power planning
The maximum number of satellites and subwoofers that can be used
in a system will depend on the quantity of amplifier’s available power.
Before beginning an installation use the chart below to calculate
the amplifier power your installation will require. multiple amplifiers
may be required in large installations.
wattage calculator
input connections
Unbalanced (most common)
To connect your audio source to the crown amplifier you will need
cables with rca connectors on the source end and bare wire on the
SLS
amplifier end. The crown amplifier channels are labeled cH1
and cH2. Both channels are identical so you can choose which
to use for right and left depending on your personal preference.
attach the bare wires from your cable to the phoenix style
connector provided in the amplifier box. note the location of the
positive and ground wires on the phoenix connector. You must run
a jumper wire from the ground terminal to the negative terminal;
see figure 1.
Balanced
when using the
SLS
in a commercial installation it might be
necessary to connect the amplifier using balanced wiring.
connect the wires from your source equipment to the phoenix
connector. Be sure to observe proper polarity when connecting the
wires to the phoenix connector. if your source equipment uses Xlr
connectors please confirm the polarity or pin out of your source
equipment before terminating the phoenix connector. See figure 2
figure 1. rca to pHoeniX connector
figure 2. Unbalanced lines to the phoenix connectors
NOTE: WHEN USING BALANCED INPUTS PLEASE CONSULT THE
CrOWN
®
AmPLIfIEr mANUAL fOr GrEATEr DETAIL.
33-5514 030713
for Technical Support, please contact Sonance
:
(800) 582-0772
©2013 Sonance. all rights reserved. Sonance is a registered trademarks of Dana innovations.
Due to continuous product improvement, all features and specifications are subject to change without notice.
for the latest Sonance product specification information visit our website: www.sonance.com
SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672-7531 USA
(800) 582-7777 or (949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (800) 582-0772
www.sonance.com
limiTeD THree (3) Year warranTY
Sonance warrants to the first end-user purchaser that this Sonance-brand product (“product”), when purchased from an authorized Sonance
Dealer/Distributor, will be free from defective workmanship and materials for the period stated below. Sonance will at its option and expense
during the warranty period, either repair the defect or replace the product with a new or remanufactured product or a reasonable equivalent.
eXclUSionS
To THe eXTenT permiTTeD BY law, THe warranTY SeT forTH aBoVe iS in lieU of, anD eXclUSiVe of, all oTHer warranTieS, eXpreSS
or implieD, anD iS THe Sole anD eXclUSiVe warranTY proViDeD BY Sonance. all oTHer eXpreSS anD implieD warranTieS,
inclUDinG THe implieD warranTieS of mercHanTaBiliTY, implieD warranTY of fiTneSS for USe, anD implieD warranTY of
fiTneSS for a parTicUlar pUrpoSe are SpecificallY eXclUDeD.
no one is authorized to make or modify any warranties on behalf of Sonance. The warranty stated above is the sole and exclusive remedy
and Sonance’s performance shall constitute full and final satisfaction of all obligations, liabilities and claims with respect to the product.
in anY eVenT, Sonance SHall noT Be liaBle for conSeQUenTial, inciDenTal, economic, properTY, BoDilY inJUrY, or
perSonal inJUrY DamaGeS ariSinG from THe proDUcT, anY BreacH of THiS warranTY or oTHerwiSe.
This warranty statement gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not allow
the exclusion of implied warranties or limitations of remedies, so the above exclusions and limitations may not apply. if your state does not
allow disclaimer of implied warranties, the duration of such implied warranties is limited to period of Sonance’s express warranty.
Your product model and Description:
SLS
crown
®
amplifier.
warranty period for this product: Three (3) years from the date on the original sales receipt or invoice or other satisfactory proof of purchase.
additional limitations and exclusions from warranty coverage: The warranty described above is non-transferable, applies only to the initial
installation of the product, does not include installation of any repaired or replaced product, does not include damage to allied or associated
equipment which may result for any reason from use with this product, and does not include labor or parts caused by accident, disaster,
negligence, improper installation, misuse (e.g. overdriving the amplifier or speaker, excessive heat or cold or humidity, outdoor installation),
or from service or repair which has not been authorized by Sonance. obtaining authorized Service: To qualify for the warranty, you must
contact your authorized Sonance Dealer/installer or call Sonance customer Service at (800) 582-0772 within the warranty period, must
obtain a return merchandise number (rma), and must deliver the product to Sonance shipping prepaid during the warranty period, together
with the original sales receipt, or invoice or other satisfactory proof of purchase.
W I R E G A U G E C H A R T
WIRE GAUGE
18 Gauge
16 Gauge
14 Gauge
12 Gauge
DISTANCE
Up to 100 Feet (33 meters)
Up to 150 Feet (50 meters)
Up to 250 Feet (80 meters)
Up to 600 Feet (192 meters)
NOTE: Please refer to the wiring chart below to determine
which size wire to use over a given distance.
*The lS15SUB is a dual voice coil, single-stereo subwoofer.
each voice coil draws 200 watts, for a combined total of 400
watts. The lS15SUB requires a 4-conductor wire to connect
both it’s left and right channel inputs.
model
Qty.
ch.1
Qty.
ch.2
x
watts
Total
ch.1
Total
ch.2
lS47SaT
x
25
LS67SAT
x
25
lS87SaT
x
50
lS10SUB
x
100
HS10SUB
x
100
lS12SUB
x
100
LS15SUB*
x
400
Sub Total
20% Head
room
TOTAL WATTAGE
