INSTALLATION
1. Before installation, carefully remove packaging, and make sure not to damage the appliance or
the connecting cable. The appliance must not be operated if damaged in any way!
2. Take out the appliance from the box!
3. Fasten the enclosed bases to the bottom of the heater (
3. figure
). Use the 4 small screws for
each for that purpose.
4. Stand the appliance on its feet on a hard, flat surface!
5. If it is used wall mounted, mount the appliance without bases on the wall, using the enclosed
fittings (
4. figure
).
a. Remove the wall consoles from the back of the appliance after loosening the two safety
screws.
b. Fasten the wall console with wall studs and 4 screws to the wall. Use studs conforming to the
size of the screws and structure of the wall. Make sure the wall console stays horizontally on
the wall.
c. Hang the 2 hangers located at the bottom of the back side of the appliance onto the screws,
then tilt towards the wall hook the two upper fixing point as well.
d. Tighten the safety screws.
6. To ensure proper operation, free circulation of hot air must be ensured. Therefore, please,
observe the minimum installation distances indicated in the
2. figure
!
7. The switches on the appliance must be in OFF position!
8. Connect the appliance into a standard grounded wall power socket! Now the appliance is
ready for operation!
Do not cover!
Covering the unit can cause overheating, fire or electric shock!
Caution: Risk of electric shock!
Do not attempt to disassemble or modify the unit or its
accessories. In case any part is damaged, immediately power off the unit and seek the
assistance of a specialist
.
In the event that the power cable should become damaged, it should only be replaced by
the manufacturer, its service facility or similarly qualified personnel.
FEATURES
electric heater for warming the atmosphere of indoor premises • can be controlled with touch buttons or with smartphone application • adjustable output 500 W / 1000 W
• electronic thermostat • 24-hour switch off timing • weekly program • child lock • IPX4 protected against splashing water • metal front panel • wall-mountable, or
standalone design • automatic switch off in case of overheating
STRUCTURE (Figure 1.)
1.
main switch •
2.
removable base (included) •
3.
screws for fixing the base •
4.
wall console •
5.
safety screws •
6.
screws, studs •
7.
power cable •
8.
metal front panel •
9.
screen •
10.
heating stage selector •
11.
timer •
12.
off/on touch button •
13.
child lock •
14.
temperature setting
OPERATION
The unit can be controlled with its touch buttons or with free smart phone application.
With the appliance’s touch buttons: After you have connected the appliance to the power network, switch it on with the main switch. It emits a short beep. You can
switch on or off
the appliance with the button. On the left side of the screen, the measured temperature, on its right side the set temperature is readable. With the
50 Hz electric wall outlets!
26.
Unwind the power cable completely!
27.
Do not lead the power
cable on the appliance, or near the air inlet and outlet openings!
28.
Do not lead the power cable
under carpets, doormats, etc.!
29.
Do not use extension cords or power strips to connect the
appliance!
30.
The appliance should be located so as to allow easy access and removal of the
power plug!
31.
Lead the power cable so as to prevent it from being pulled out accidentally or
tripped over.
32.
The appliance is intended for household use. No industrial use is permitted!
33.
Due to continuous improvements, the technical data and design may change without any prior
notice.
34.
The actual instruction manual can be downloaded from www.somogyi.hu website.
35.
We don’t take the responsibility for printing errors which may occur, and apologize for them.
