Sommerkamp TS-732P, Инструкция по эксплуатации

Страница: 6 / 15

Mounting bracket and screws are supplied for mounting the transceiver underneath
the dashboard. Microphone hanger and screws are also supplied.
For electrica! connection, firs t make sure that the transceiver is turned off.
Connect the red wire to the ACC terminal of the ignition switch or + terminal
of battery and ground the red and white or black wire to the chassis of the
vehicle. The black wire should be grounded as short as possible to minimize noise
interférence.
This transceiver is designed for use with the negative ground system.
OPERATING INSTRUCTIONS
The transceiver is ready to operate when it is installed with an antenna properly
connected. Note that the communication range differs depending upon the environ­
ment where the transceiver is operated. You may reach 30 or 40 kilometers
where no obstacle exists, but the range may be limited to 5 or 6 kilometers in
cities where many high buildings disturb the communication.
1) Turn the set on by switching the ON-OFF snap switch to ON and the channel
dial will be lighted. Turn the volume contro! clockwise to increase the audio
Sound. Note that the volume controi knob is only for adjusting the audio
volume, not to increase the transm itting power.
2) Turn the squelch controi clockwise until incoming noise is eliminated. Do not
turn it excessively as the sensitivity may be reduced.
3) Turn the squelch controi counter-clockwise to switch o ff the ANL
(Automatic Noise Limiter)
4) Turn the channel selector knob to the desired channel.
5) For transmitting, press the button on the microphone and speak into it normally.
Release the button for receiving.
METER
The meter reading indicates the signal strength at receiving, and functions as an
output indicator at transmitting, and the meter pointer should be within the Red
zone under the normal conditions.
MOBILE INSTALLATION
6