Sommer & Maca Industries VFE-4, Руководство пользователя

Страница: 44 / 44

Programming of “Mini-Job” Controller
Caution: Parameters have been factory set. Changes to these settings without consulting supplier may void
warranty.
The procedure for making program or parameter changes of the distance settings from the glass micro switch are
as follows:
1.
Insert the proper key into the keyed switch and
turn the key clockwise to switch to
programming mode.
2.
Press F and then 1 . The word ACCES will
appear at this time.
3.
Press C and in sequence the numbers 14863 .
4.
Press M to confirm the parameter settings. The
first parameter that will appear on the screen is
the
CC , which is the ratio between the encoder
and the shifting of glass; it is always fixed at
2300 .
5.
Press M, The second parameter is LO, which is
always set at 60 .
6.
Press M . NL will display.
7.
Enter 1 to program NL1, which is the set of
parameters to program the distance between the
first seam wheel (spindle
M2) and the glass
micro switch of entrance.
Notes : it is possible to program NL1, 2, 3
or 4 in different modes, in our case all
parameters are to be set in AUT .
8. Press the M key to select AUT .
9.
Press M . The will automatically see DS, which
is the distance of the grinding wheel to the glass
micro switch of entrance, then enter value of
(360) (see Figure1 & 2) .
10.
Press M , you will automatically see E1 , then
enter the pre-insertion value of “ -25” (see
Figure1 & 2) .
11.
Press M and you will automatically see E0,
then enter the grinding wheel post-release value
of
“40” (see Figure1 & 2) .
12.
Press M to memorize and the display will show
END
13.
Wait for 5-7 seconds. After NL will display
again, enter 2 to set NL2 or 3 to set NL3 .
14.
After you entered NL1, NL2 and NL3 , you
need to switch to operating mode. After the
waiting period of 5-7 seconds that precedes the
display of
END, enter F , enter 6 then switch
and turn the key counter-clockwise to switch
from programming to operating mode.
SPINDLE DS E1 E0
NL1 M3 360 -25 40
NL2 M4 518 -25 40
NL3 M5 760 -15 30
VFE-6 PROGRAMMING PARAMETERS
Figure1
Figure2
DS
glass travel
E0 E1
POLISH
OR
SEAM WHEEL
SWITCH