Copyright © Somfy SAS 3/2019 P-0037
Perform double power cut:
Power
ON
Cut power
for 2 sec.
Cut power
for 2 sec.
Power
ON
Power back
ON for 8
seconds
FACTORY RESET
Once the motor stops
moving on its own, press &
hold the
PROGRAMMING
BUTTON
on the back of
the remote and count to ten
without letting go.
The motor should jog twice.
10 SEC.
The motor should start to move and then stop on its own.
If it doesn’t, repeat the power cut until it does.
2X
CLOSING FORCE
function on cassette awnings only
This function can be increased or decreased to 3 levels (high/medium/low). Factory level is medium. To change the closing force level:
Step 1:
Briefly cut power, unless
you are using the awning
in the first 4 cycles.
Step 2:
Bring the awning
to the halfway
position.
Step 3:
Briefly press the
MY and UP
buttons simultaneously,
then immediately press and hold the
MY and UP
buttons until the motor jogs. The motor is only in
programming mode for approx.10 seconds.
Step 4:
Step 5:
Press the
MY
button until the
motor jogs:
The new closing force has
been programmed.
To
DECREASE
the
closing force, press
the
DOWN
button
until the motor jogs
up and down.
To
INCREASE
the
closing force, press
the
UP
button until
the motor jogs up
and down.
BACK RELEASE
function on cassette awnings only
This function allows the fabric tension to be released after the cassette awning is closed. To activate this function:
Step 1:
Briefly cut power, unless
you are using the awning
in the first 4 cycles.
Step 2:
Set the awning
to the upper limit
position.
Step 3:
Press the
MY
and
DOWN
buttons until the motor jogs:
If the Back release function was deactivated, it is activated.
If the Back release function was active, it is deactivated.
BACK IMPULSE
function for both cassette and standard awnings
This function allows you to apply tension on the fabric when the awning is fully extended.
The motor can be adjusted up to a ½ half turn. To activate this function:
Step 1:
Set the awning to
the lowest position.
Step 2:
Press the
MY and UP
buttons until the awning
jogs: The motor is in
programming mode.
Step 3:
Adjust the fabric’s
tension using the
UP
or
DOWN
buttons.
Step 4:
Press the
MY
button until
the motor jogs:
The fabric’s tension has
been programmed.
OR
The procedure to delete a RTS sensor is the same.
a) Press & hold the
PROGRAMMING BUTTON
on the back of Control 1 until
the motor jogs.
b) Briefly press the
PROGRAMMING BUTTON
on the back of Control 2 until
the motor jogs.
CONTROL 1: Previously
programmed control
CONTROL 2: Second control
to be added or deleted.
ADD OR DELETE A CONTROL
ADJUSTING THE LIMITS IN USER MODE
To change the lower limit:
Move the motor to its current lower limit position and let it stop. Press the
UP and DOWN
buttons simultaneously until the motor jogs, then release. Adjust to a new lower limit
position. Press the
MY
button until the motor jogs, then release. Check the new limit.
To change the upper limit:
Move the motor to its current upper limit position and let it stop. Press the
UP and DOWN
buttons simultaneously until the motor jogs, then release. Adjust to a new upper limit
position. Press the
MY
button until the motor jogs, then release. Check the new limit.
OR
OR
