SOMFY SDN 0-10V Interface V2, Быстрый старт

Страница: 2 / 4

2
SDN 0-10V Interface V2
The SDN 0-10V Interface control is
a device that will accept an industry
standard 0-10V dimming signal and
convert it to a Somfy Digital Network™
(SDN) signal. TThe SDN signal can
drive a single or multiple Somfy RS485
motors via assigned group addresses.
Key features include:
• One control can drive up to
30 SDN tubular motors.
• Provides 20 SDN Bus
Power units
MOTOR %
POSITION
MOTOR
INTERMEDIATE
POSITION
.750 V 0% IP1
1.088 V 10% IP2
2.037 V
20% IP3
2.973 V 30% IP4
3.901 V 40% IP5
4.897 V
50% IP6
5.813 V 60% IP7
6.73 V 70% IP8
7.71 V 80% IP9
8.66 V 90% IP10
9.58 V 100% IP11
MOTOR %
POSITION
MOTOR
INTERMEDIATE
POSITION
.750 V 0% IP1
1 V 10% IP2
2 V
20% IP3
3 V 30% IP4
4 V 40% IP5
5 V
50% IP6
6 V 60% IP7
7 V 70% IP8
8 V 80% IP9
9 V 90% IP10
1. Verify that the limits of the RS485 motor are set and the power to the motor is applied.
2. Connect the motor data cable and the 0-10V input according to Figure 1. Do not connect the 120V AC power supply
at this time.
*NOTE* VERIFY THE POLARTIY OF THE 0-10V POSITIVE (+) PURPLE AND NEGATIVE (-) PINK INPUTS BEFORE
APPLYING POWER.
3. Connect the SDN 0-10V Interface and turn on the AC power. Then verify that the Main Power LED on the Bus Out jack
is solid green. The Bus Activity LED turns on for 10 seconds then turns off.
4. Verify that the motor responds by a single press of the pin-hole push button.
SETUP
(Please refer to the programming guide on the product page for step-by-step instructions.)
INSTALLATION AND WIRING
Line/Hot
Black wire
Line Voltage and
0-10V Dimming
SDN Bus
Negative (-)
Pink wire
SDN 0-10V
Interface V2
Connects to an
SDN Bus-in Port
or a Device Port
Neutral
White wire
Positive (+)
Purple wire