SOMFY LT50 CMO, Руководство по установке

Страница: 14 / 36

Copyright © 2007-2016 Somfy SAS. All rights reserved.
LT 50 CSI - LT 60 CSI
14
EN
0RWRUWXEHDVVHPEO\
1) Slide the motor into the roller tube.
For smooth roller tubes, position the notch previously cut on
the crown.
2) Fix the roller tube to the drive wheel with 4 x Ø 5 mm self-
tapping screws or 4 steel pop rivets of Ø 4.8 mm located:
- at least 5 mm from the far end of the drive wheel: L1 - 5,
and
- no more than 15 mm from the far end of the drive wheel.
N.B.: the screws or pop rivets must only be attached to the
drive wheel and not to the motor.
)LWWLQJWKHDGMXVWPHQWSXOOWDEVRSWLRQDO
The motor can be supplied, optionally, with two adjustment
pull tabs. These pull tabs can be used to operate the
adjustment push-buttons when they are not accessible.
- Remove the protective housing.
- Fit the pull tabs on the motor head.
&DXWLRQ7KHSURWHFWLYHKRXVLQJFDQQRWEHUH¿WWHGZKHQXVLQJ
these pull tabs.
=
)LWWLQJWKHHPHUJHQF\FUDQN
Fit the crank handle onto the motor head.
)LWWLQJWKHPRWRULVHGWXEH
- Mount the motorised tube on the end bracket.
- Mount the motorised tube on the motor bracket.
:LULQJ
- Switch off the power supply.
- Connect the motor according to the information in the table
below:
9 9 :LUH
1
Blue White Neutral
2
Brown Black Live
3
Black Red Live
4
Yellow/Green Green Earth
3 x 1,5 mm2
P
4 x 0,75 mm
2
1
4
230 V - 50 Hz
120 V - 60 Hz
1
2
L1
5 m
10 mm