SOMFY Dexxo Pro 1000 io, Руководство пользователя

Страница: 5 / 24

5
EN
End limit setting and self-learning
Fig. 16
PROGRAMMING
Programming button description
For swinging doors, change the P9 setting before starting self-learning.
[1]. Press the “ SET ” button until the light comes on (2 s).
The display shows “ S2 ”
[2]. Control the motor using the “ + ” or “ - ” buttons so that the transmission system runner moves to link up with the trolley and closes the door.
• Pressing and holding the “ - ” button closes the door.
Release the “-” button before the motor has time to force against the door.
• Pressing and holding the “
+
” button
opens
the door.
[3]. Adjust the closed position using the “ + ” or “ - ” buttons.
Release the “-” button before the motor has time to force against the door.
[4]. Press “ OK ” to validate the closed end limit position and start the self-learning cycle.
The door runs through a complete Open Close cycle.
• If learning was correct, the display will show “ C1 ”.
• If the learning cycle was not completed correctly, the display will show “
S1
”.
During the learning cycle:
• If the door is moving, pressing any button will stop the movement and interrupt the learning mode.
• If the door is stopped, pressing “
SET ” once will exit the learning mode.
You can call up the learning mode at any time, even when the learning cycle has already been executed and the display shows “ C1 ”.
Keytis remote control description
Fig. 17a
1
Individual control buttons
2 General STOP button
3 General CLOSE button (Keytis 4 home io only)
4
Operation indicator light On Intermittent Blinking
5 Low battery indicator light
6
Closing clip
7
PROG button: programming the transmitter
8 KEY button: memorising the system key
Keygo remote control description
Fig. 17b
1
Individual control buttons
2
Operation indicator light On Intermittent Blinking
. Press for 2 s: memorise remote controls
. Press for 7 s: delete remote controls
. Modifying a setting value
. Using the forced mode
. Selecting a setting
. Start the learning cycle
. Confirm setting selection
. Confirm setting value
. Press for 0.5 s: call up and exit the setup menu
. Press for 2 s: start learning
. Press for 7 s: clear learning and settings
. Stop learning