© 2013, Somfy SAS. ALL RIGHTS RESERVED.
REF 5116878
- 20131122
Installation and connection
The housing of the KNX IP Interface wireless has the following
dimensions: 125 x 67 x 31 mm.
It has the following connectors, display elements and buttons:
24,00 mm
4
,0
0
m
m
5
,5
0
m
m
47,40 mm
TEST
KNX/IP Interface
wireless
9
V
=
-K
N
X
+
Weinzierl
RUN
WLAN
KNX
PROG
740
4
5
6
7
8
9
1
2
3
1:
Antenna Terminal
2:
External power supply connection (9 V DC)
3:
Connector for KNX/EIB with a bus terminal
4:
RUN LED (green):
- Blinks quickly during the startup phase (approx. 40 sec-
onds)
- Lights up to indicate the device is operational
5:
WLAN LED (green):
- Flashes to indicate telegram activity
6:
KNX LED (green):
- Lights up to indicate the KNX/EIB is available
- Flashes to indicate telegram traffic
7:
Programming Button
8:
Programming Mode LED (red)
9
Test mode button:
While this button is pressed the device goes into test
mode. In test mode the display elements have the following
meaning:
- RUN LED: blinks slowly and indicates the device is in
test mode
- WLAN LED: off
- KNX LED: on when an active connection is available,
otherwise off
The connection to the mains (230 V~/50 Hz) is done via the en-
closed wall power supply.
The KNX IP Interface wireless is delivered in a plastic case with
the following content:
- Wall power supply (Primary: 230 V~/50 Hz, Secondary: 9 V=)
- Antenna (SMA-R connector)
- Pluggable screwing terminal for the connection of the KNX/EIB
bus
- Documentation
SOMFY
50 avenue du Nouveau Monde
BP 152 - 74307 Cluses Cedex
France
