Somati system s.r.o.
, Jihlavská 510/2c, 664
41 Troubsko
IČ: 29260159, DIČ: CZ29260159
tel: +420 547 427 011, www.somati-system.cz
28
Picture 37
Install the remaining sections the same
way. Before installing the next section, al-
ways check the horizontality and verticality
of the already-mounted sections and the
possible passage door width in case of gate
with passage door.
After the next section is correctly mounted,
fix it with self-drilling screws TEX 6HR
6,3x38 mm through the holes in hinges.
Picture 38
Fit the upper hinges with pulleys [4.6] to
the pre-drilled holes
∅
4 mm at the upper
corners of the last section with the top
edge [4.4]. Adjust the pulley as you did on
the previous sections.
Picture 39
In case of gate with passage door, continue
with installation of the door leaf. It always
opens towards the building opening.
On the gap between the first and second
section, project the horizontal line and align
the first section of the passage door ac-
cording to that. The gap between the bot-
tom profile [4.5] and the gate leaf is se-
cured by mounting underlays (prepared
from production),which should be removed
after mounting of all sections. Anchor the
leaf hinge to the fixed section. For the top
hole of each hinge use screw M8x30, and
TEX 6,3x38 self-drilling screws for remain-
ing holes.
Horizontal placement of the leaf towards
the fixed sections
–
see pic. 40.
