4G-54RV
300M Wireless 4G Router Quick Installation Guide
Flashing
Data is being received or sent through
the RJ-45 port.
WAN
Always
on
WAN port is connected to ethernet
equipment properly.
Flashing
WAN port is receiving or sending data.
Zigbee
Option not fitted
System
indication
Start
3G/4G
①
Quick flashing (0.5 sec/time): 3G/4G
modem starts dialing up.
②
Always on: 3G/4G dial-up success
③
Off: 3G/4G dial-up network is not
established
Insert TF
card /
USB
drive
①
Always on: A storage device is
successfully loaded.
②
Off: A storage device is not loaded.
Product installation
Inserting the Sim:
Remove the 2 screws on the underside of the router to reveal the sim slot. Slide the
silver sim cover towards the back of the router, it will then lift on a hinge, place the
sim in the holder, put down the cover and slide forward, it should click into position.
Replace the cover and power up the router.
Hardware connection
Please use ancillary power adapter to supply power for router, start router, and then
connect your computer to the RJ45 port on the router by using a RJ45 network cable.
If you’re using wifi it should appear as SmartWIFI-xxxx, the default password is:
12345678. You can change this to something more secure later in the WiFi, Security
settings. We recommend you to connect with wire method. The following setting steps
are all based on wire connection.
Set up your computer network in a correct way
The router default LAN port’s IP address as 192.168.169.1 and default subnet mask as
255.255.255.0. My default, when you connect to the router then your computer should
be allocated a suitable network address to enable you to go directly to the web
configuration page.
3
