To remove the remaining 2-3 litres: Lift the dome and ABS support out of the bowl. You may need to
unscrew the flex hose from the pump to achieve this. Then bail out remaining water with a yogurt
container and then a sponge for the last remnants.
To refill the bowl reverse the process.
1.
Feed electrical plug through Split Plug Cap first!
Make sure the Split Plug Cap is facing the correct direction. You will need to screw this onto the
threaded bulkhead fitting to secure the rubber Split Plug in place.
2.
Pull through as much electrical cord as needed. Leave enough cord inside the bowl for slack and fit
the rubber Split Plug around the cord and push into the bulkhead opening. The soft rubber will
squeeze around the cord and fill the opening, making for a water tight seal.
It’s best to wiggle around the cord a bit while pushing in the rubber plug. This will help to seal any
gaps. You may also need to pull and push on the cord to get a water tight seal. You may also use a bit
of olive/vegetable oil as a lubricant to help seat it.
3.
Once the rubber Split Plug is about 7/8 of the way in, start to screw on the Split Plug Cap. This only
needs to be finger tightened. It prevents the plug from backing out of its own accord.
4.
Add a few liters of water to check for leakage. Adjust and wiggle the cord/split plug until leakage
stops.
5.
Then reattach the flex hose to the pump and replace the dome and ABS assembly. Making sure the
stainless steel prongs are
inside
the ABS cylinder.
6
Add the appropriate amount of water and your ready to go again.
If you have any questions, please get in touch with us at:
Solus Decor
1-877-255-3146 or 604-215-0441
[email protected]
Solus Decor UK Ltd
0208 819 1495
[email protected]
9
DOME 26, 36 & 48
Table of Contents:
1. Title page
2. General Warnings
3. Exploded diagram
4. Indoor/Outdoor set up
5. Components
6. Installation
7. Draining-Outdoors
8. Draining-Indoors
9. Refilling
solus
Contemporary Design,Crafted in Concrete
Water Feature