SOLTRON V-50 Turbo Power, Руководство по эксплуатации

Страница: 35 / 106

34
Safety information for the operator
• All danger and safety notes attached to the device must be observed!
• Please see the
Technical Data – page 89 for the maximum permis-
sible weight loading of the floor plate.
• No safety equipment (e.g. panel switch) or safety warnings may be
removed or deactivated which would impair the safe operation of the
device!
• The device may only be operated in full working order!
1) In Germany: VDE regulations
• A timer must be installed so that the unit is automatically switched off
at the latest after <110% of the selected operating time even when
the controller fails. The device operating time must therefore have
dual regulation by means of a timer, as set forth in EN 60335-2-27.
2)
• Do not change, obstruct or block the air inflow and outflow area to the
device or make any unauthorised changes to the device. The manu-
facturer shall bear no liability for damage or injuries resulting from
such actions.
• The ventilation data must be observed without fail (see page 97).
2) For JK timers, see Page 98
Danger!
Installation and electrical connections must comply with the na-
tional regulations.
1)
The electrical installation is to be fitted with an easily accessible
all pole isolating device (master switch) on the building side,
complying with overvoltage category III. This means that each
pin shall have a contact opening width complying with the condi-
tions of overvoltage category III for full isolation.
If the unit is connected via a plug and socket connection, a plug
system complying with EN 60309-1/A11; 5-pole; 400 VAC (25 A)
must be used.
Assembly, installation, upgrading or repair of the device may
only be carried out by specially trained and instructed personnel.