65MV/65MV-X
56
Onboard FDC
Controller
Select Enabled if your system has a floppy drive con-
troller (FDC) installed on the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial
Port 1 / Port2
Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
UART 2 Mode
This item allows you to select which mode for the
Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR
IR Function Duplex
This item allows you to select the IR half / full duplex
function.
The choice: Half, Full.
TX, RX inverting
enabld
This item allows you to enable the TX, RX inverting
which depends on different H/W requirement. This
field is not recommended to change its default set-
ting for avoiding any error in your system.
The choice: “No, No”, “No, Yes”(default), “Yes, No”,
“Yes, Yes”.
Onboard Parallel Port
This item allows you to determine onboard parallel
port controller I/O address setting.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7,
Disabled.
Onboard Parallel Port
Mode
Select an operating mode for the onboard parallel
(printer) port. Select Normal, Compatible, or SPP
unless you are certain your hardware and software
both support one of the other available modes.
The choice: Normal , EPP, ECP, ECP/EPP.
ECP Mode Use DMA
Select a DMA channel for the parallel port for use
during ECP mode.
The choice: 3, 1.