014
015
09
Remote Control Guide
1.
On/Off
2.
Connect/Test
4.
20%~80% Motion
Sensor Mode (Default)
6.
Early Bird Mode
8.
70% Constant Mode
10.
Timer Mode Disabled
12.
Time Mode 8 Hours
3.
40%~100% Motion
Sensor Mode
5.
Night Owl Mode
7.
100% Constant Mode
9.
40% Constant Mode
11.
Timer Mode 4 Hours
1. On/Off
When off is selected, the light will stop working. Solar panel will not
charge the battery and the battery will not supply electricity to the light.
2. Connect/Test
Remote control device can be connected with any lighting fixture, one
at a time. To connect, press the button once. It also functions as a test
button. To test, press the “Test” button once, the red light will indicate
the fixture is charging, green light indicates that the fixture is operating.
Testing lasts for 10 seconds, then goes back to the mode previously
in use.
When using the remote for the first time, please remove the plastic
piece at the bottom to make the remote turn on.
3. 40%~100% Motion Sensor Mode
Constant 40% brightness (turn on at dusk, turn off at dawn);
100% brightness turns on for 30 seconds when motion detected.
4. 20%~80% Motion Sensor Mode (Default)
Constant 20% brightness (turn on at dusk, turn off at dawn);
80% brightness turns on for 30 seconds when motion detected.
5. Night Owl Mode
Changes as natural light decreases/increases (turn on at dusk); 70%
brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness
for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours (turn
off at Dawn).
6. Early Bird Mode
Changes as natural light decreases/increases with increased brightness
near dawn for early risers (turn on at dusk); 70% brightness for 0.5
hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50%
brightness for 1 hour, 20% brightness for 4 hours, 100% brightness
for 1 hour (turn off at Dawn).
Important
Dust and dawn time may be diffrent in other locations and seasons.
The sensors of our products will follow the light patterns of where it is
installed. The time period shown in the chart above is just an example
to help you understand the different lighting modes only.
(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of the Sunlike ECO—IAP under
shady trees, heavy rain, and thick clouds, our controllers now
integrate an adaptive smart control feature to actively track battery
capacity and adjust light output accordingly. Before integrating this
feature, selecting a light output percentage on the remote would yield
an accurate percentage of max LED brightness. Now with (IAP), the
controller actively monitors the battery and regulates the electrical
current to the LEDs. The controller makes light output of the selected
percentage on the remote relative to battery capacity rather than
max LED output. This smart-control feature can increase our off-grid
performance by up to 40%.
16ft–33ft
The range of the remote control to the
indicator is 16ft (Day time) to 33ft (Night
time). Because the sunlight will impact
the signal of the remote control, we suggest
our users to setup the mode before they
install the light.
30 sec
30 sec
30 sec
