04
05
01
Introduction
Thank you for purchasing the TWINKO mobile solar light tower.
Introduction
Outdoor solar lighting systems use solar cells which convert sunlight
into electricity. Electricity is stored in batteries for use at night.
TWINKO Mobile Solar Light Tower combined with SUNLIKE solar lights
are easy to install and virtually maintenance free. Using them avoids
trenching, cabling, and electricity costs .
Important
In order to avoid deep discharge of the battery during storage, please
fully recharge your battery every 4 months. Please make sure that the
light is installed in an area with sufficient sunlight. A strict minimum
of 3.5 hours/day of sunshine on average is recommended. Select the
right operating mode according to local codes and solar conditions. Keep
it away from shadows. Self-cleaning occurs when the light fixture has
minimum angle of 15 degrees above horizontal.
26.0 inches
36.0 inches
36.0 inches
17.0 inches
17.0 inches
17.0 inches
4.0 inches
4.0 inches
4.0 inches
4.7 inches
10.5 inches
31.4 inches
6.9 ft
37.9 inches
16.0 ft
7.5 inches
45.2 inches
17.0 inches
6.0 inches
3.0 inches
S
UNLIKE
20W
S
UNLIKE
30W
S
UNLIKE
PR
O 30
W
Charging Point DC14.6V 3.75A
Red & Green Indicator
Light Module
Charging Point DC14.6V 3.75A
Red & Green Indicator
Light Module
Please save these instructions. Read all of the instructions carefully
before attempting to carry out any installation or wiring. Do not open or
attempt to repair a SOLTECH luminaire on your own, as it many cause
serious damage and would void the product warranty. Contact your
local distributor for any questions concerning the installation.
Range of the lighting fixtures is 20–26 feet (6–8 meters). The ideal
installation spacing betweeen fixtures is <16 feet (5 meters). When
installing two or more light fixtures on one pole, select desired operating
mode before installation. Radio frequency interference can cause
delay or malfunction of the remote control when changing operating
modes, after installation.
Precautions when working with solar panels
When the solar panel is exposed to sunlight, a voltage appears at the
output terminals of the solar panel, turning it into a source of electricity.
To avoid a shock hazard, make sure the solar panel is covered with an
opaque (dark) covering, such as paper or cloth, during the installation.
Do not make contact with the terminals when the panel is exposed to
sunlight or any other light source.
Luminaire Options
Charging Point DC14.6V 3.75A
Indicator
Light Module
