Soltech CEGONIA PRO 30W, Руководство по установке

Страница: 4 / 20

04
01 Introduction
Thank you for purchasing CEGONIA PRO solar-powered area light.
Introduction
CEGONIA PRO combine stylish design with hight efficiency. You can adjust
both the tilt angle and the azimuth to make sure the panel is in the optimal
position to capture the sun’s energy. It is a perfect fit for courtyards, parks,
schools, communities and paths.
Important Considerations
In order to avoid deep discharge of the battery during storage, please
fully recharge your battery every 4 months. Please make sure that the
light is installed in an area with sufficient sunlight irradiance. A strict
minimum of 3.5 hours/day of sunshine on average is recommended.
Select the right operating mode according to local codes & regula-
tions, and the local sunshine conditions. Keep it away from shadows.
Self-cleaning occurs when the light fixture has a minimum angle of
15 degrees.
Please save these installation instructions. Read all of the instructions
carefully before attempting to carry out any installation or wiring.
Do not open or attempt to repair the product on your own, as it many
cause serious damage and would void the product warranty. Contact
your local distributor for any questions concerning the installation.
Range of the light module on the lighting fixture is 20–26 feet (6–8
meters). The ideal installation spacing is >16 feet (5 meters). When
installing two or more lighting fixtures on one pole, select desired
operating mode before installation. Interference can cause delay or
malfunction when using the remote control to change operating modes
after installation.
Range of the light module on the lighting fixture is 20–26 feet (6–8
meters). The ideal installation spacing is >16 feet(5 meters). When
installing two or more lighting fixtures on one pole, select desired
operating mode before installation. Interference can cause delay or
malfunction when using the remote control to change operating modes
after installation.
Precautions When Working With Solar Panels
When the solar panel is exposed to light, a voltage appears at the
output terminals of the solar panel turning it into a source of electricity.
To avoid a shock hazard, make sure the solar panel is covered with an
opaque (dark) covering such as paper or cloth, during the installation.
Do not make contact with the terminals when the panel is exposed to
sunlight or any other light source.