- 13 -
2.2.
Test Run
You can perform test run according to the following orders. The test run described here
is based on the assumption that the IP address of the PC is set to 10.1.0.2 and its serial
interface is configured as RS232 interface.
2.2.1.
Changing PC IP Address
You can change the IP address of your PC as follows:
IP Address
10.1.0.2
Subnet Mask
255.0.0.0
Gateway IP Address 0.0.0.0
2.2.2.
Installing EZL-300S
Connect the AP with the PC through the crossed LAN cable.(When connecting through
a hub, use a one-to-one cable for this connection.) After installing the cable, supply
power to the AP as provided by the AP vendor. After supplying power, check the link
LED indicating a connection between the AP and PC to make sure this connection is
successfully made.
2.2.3.
Configuring EZL-300S
Configure EZL-300S setting using ezConfig, the ezTCP configuration program, as
follows.
Run ezConfig, and click [Search ezTCP] button in the ezConfig window. And, ezConfig
program will search all ezTCPs on the local network.
When ezTCP is searched, MAC address of the ezTCP is displayed on the [Search List]
window (The MAC address is indicated at the bottom of the product case).
Select the corresponding MAC address, and set the same as shown in the following
figure and click [Write] button to save the settings.