EN
Solight WO772 LED solar light
Dear customer, thank you for purchasing our product. Please carefully read and abide by the following instructions to ensure
that this product is used safely and to your complete satisfaction. This will also help avoid any improper use or damage. Prevent
any unskilled handling of the device and always follow the principles of use for electrical appliances. Store these instructions in a
safe place.
Specification
Voltage
DC 3,7V
Rated power
8W
Discharge current
2,2A max.
Working time
1 hodina (max. 120 sepnutí)
Max. detection range
8m
Max. detection angle
110°
IP Protection
IP44
Battery type
1x 18650 Li-
Ion 2000mAh
Solar panel
5V / 1,5W – 300mA
Working temp. / humidity
-20°C to +50°C
Installation
1.
Select a suitable mounting location so that the panel is exposed to sunlight
2.
Mount the lamp holder to the wall with screws. Recommended height is 2–2.5 m above the ground (Fig. A)
3.
Slide the light onto the holder (Fig. B)
4.
Secure with a screw (Fig. C)
5.
Set the position of the light to lighten the desired location
6.
Leave the light off and charge it for at least 10 hours
7.
Switch on the light with the switch on the bottom.
8.
Set the lighting time and light sensitivity with the TIME and LUX knobs, see below for more information.
9.
PIR sensor, light and solar panel can be adjusted at different angles.
Sensor and lighting duration settings
Using the rotary knobs on the top of the reflector, you can set the lighting time (TIME) and set the
sensitivity depending on the ambient lighting conditions. The time can be set from 10 to 60 seconds. If
motion is detected more than once within a single time interval, the time is added up.
Charging and maintenance
Charging takes place automatically on sunny days. A full charge takes about 10 hours during summer days. In winter about 3
days. Keep the solar panel clean for maximum efficiency. If you need to replace the battery, first remove the reflector from the
holder. Then unscrew the two screws and open the battery cover. Replace the battery, replace the cover, tighten the screws,
and slide back onto the bracket.
The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced.
Manufacturer:
Solight Holding s.r.o., Na Brně 1972,
Hradec Králové 500 06
