Solidyne MB 2100, Руководство пользователя

Страница: 16 / 22

The attenuator MIC-4/LINE sends signal from microphone
or line input. When plugging a plug into the line input, the
internal microphone disconnected.
3.1.2.2 CUE Mixer (headphones)
At this stage is generated the headphone mix. The knob-
control with zero at center regulates the level of signals
STUDIO, which is the return from Studios sent through the
telephone line, and MIXER, which is local mix of
microphones generated by the console.
Turning the CUE knob to position MIXER you will hear only
the local mix generated in the console, and not hear return
from Studios.
With the knob at STUDIO position you will hear the return
from Studios, which reaches the MB-2100 through
telephone communication, listening while the signal from
the console MB-2100.
Therefore when you test the microphones you must use
this control at MIXER position. But when the transmission
started via cellular or land-line, you must turn the CUE
knob to STUDIO to listen both the return signal (journalists
who are at the radio station) as the local signal generated
by the MB-2100.

Note:
It is not necessary that the operator in Studios forward the radio signal
received from the MB-2100. At the location the journalist will hear yourself (and
your console that transmits audio) because, of course, part of which transmits
audio MB2100 returns through phone line (or cellular). This signal is attenuated
about 15 dB over the level transmitted, but audio will good as reference.

When communication is not established, the level of monitoring of the
microphones in the position 'Studio' is higher than during the communication.
3.1.3 Signal level indicator
The console features a two-level LED's indicator that
shows the action of the internal compressor. The green
LED illuminates when the signal level is below the action of
the compressor. When the signal begins to compress, red
LED lights. The higher compression will produce more
brightness red LEDs.
Page 16 MB-2100 Portable mini-console SOLIDYNE